• Каталог /
• Картинки /
• Robert Sullivan /
• Royal Air...

Описание: The Royal Air Force unveiled impressive images of a unique aircraft formation to celebrate the forty years of service of the Panavia Tornado GR4 attack jet. From Wikipedia, the free encyclopedia The Panavia Tornado is a family of twin-engine, variable-sweep wing multirole combat aircraft, jointly developed and manufactured by Italy, the United Kingdom, and West Germany. There are three primary Tornado variants: the Tornado IDS (interdictor/strike) fighter-bomber, the suppression of enemy air defences Tornado ECR (electronic combat/reconnaissance) and the Tornado ADV (air defence variant) interceptor aircraft. The Tornado was developed and built by Panavia Aircraft GmbH, a tri-national consortium consisting of British Aerospace (previously British Aircraft Corporation), MBB of West Germany, and Aeritalia of Italy. It first flew on 14 August 1974 and was introduced into service in 1979–1980. Due to its multirole design, it was able to replace several different fleets of aircraft in the adopting air forces. The Royal Saudi Air Force (RSAF) became the only export operator of the Tornado in addition to the three original partner nations. A tri-nation training and evaluation unit operating from RAF Cottesmore, the Tri-National Tornado Training Establishment, maintained a level of international co-operation beyond the production stage. The Tornado was operated by the Royal Air Force (RAF), Italian Air Force, and RSAF during the Gulf War of 1991, in which the Tornado conducted many low-altitude penetrating strike missions. The Tornados of various services were also used in conflicts in the former Yugoslavia during the Bosnian War and Kosovo War, the Iraq War, Libya during the Libyan civil war, as well as smaller roles in Afghanistan, Yemen, and Syria. Including all variants, 992 aircraft were built. Development Origins During the 1960s, aeronautical designers looked to variable-geometry wing designs to gain the manoeuvrability and efficient cruise of straight wings with the speed of swept wing designs. The United Kingdom had cancelled the procurement of the TSR-2 and subsequent F-111K aircraft, and was still looking for a replacement for its Avro Vulcan and Blackburn Buccaneer strike aircraft.[1] Britain and France had initiated the AFVG (Anglo French Variable Geometry) project in 1965, but this had ended with French withdrawal in 1967. Britain continued to develop a variable-geometry aircraft similar to the proposed AFVG, and sought new partners to achieve this.[3] West German EWR had been developing the swing-wing EWR-Fairchild-Hiller A400 AVS Advanced Vertical Strike (which has a similar configuration to the Tornado). In 1968, West Germany, the Netherlands, Belgium, Italy and Canada formed a working group to examine replacements for the Lockheed F-104 Starfighter, initially called the Multi Role Aircraft (MRA), later renamed as the Multi Role Combat Aircraft (MRCA). The participating nations all had ageing fleets that required replacing; but, as the requirements were so diverse, it was decided to develop a single aircraft that could perform a variety of missions that were previously undertaken by a fleet of different aircraft.[10] Britain joined the MRCA group in 1968, represented by Air Vice-Marshal Michael Giddings, and a memorandum of agreement was drafted between Britain, West Germany, and Italy in May 1969. By the end of 1968, the prospective purchases from the six countries amounted to 1,500 aircraft. Canada and Belgium had departed before any long-term commitments had been made to the programme; Canada had found the project politically unpalatable; there was a perception in political circles that much of the manufacturing and specifications were focused on Western Europe. France had made a favorable offer to Belgium on the Dassault Mirage 5, which created doubt as to whether the MRCA would be worthwhile from Belgium's operational perspective. Panavia Aircraft GmbH On 26 March 1969, four partner nations – United Kingdom, Germany, Italy and the Netherlands, agreed to form a multinational company, Panavia Aircraft GmbH, to develop and manufacture the MRCA. The project's aim was to produce an aircraft capable of undertaking missions in the tactical strike, reconnaissance, air defence, and maritime roles; thus allowing the MRCA to replace several different aircraft then in use by the partner nations. Various concepts, including alternative fixed-wing and single-engine designs, were studied while defining the aircraft. The Netherlands pulled out of the project in 1970, citing that the aircraft was too complicated and technical for the RNLAF's preferences, which had sought a simpler aircraft with outstanding manoeuvrability. An additional blow was struck by the German requirement reduced from an initial 600 aircraft to 324 in 1972. It has been suggested that Germany deliberately placed an unrealistically high initial order to secure the company headquarters and initial test flight in Germany rather than the UK, so as to have a bigger design influence. When the agreement was finalised, the United Kingdom and West Germany each had a 42.5% stake of the workload, with the remaining 15% going to Italy; this division of the production work was heavily influenced by international political bargaining. The front fuselage and tail assembly was assigned to BAC (now BAE Systems) in the United Kingdom; the centre fuselage to MBB (now EADS) in West Germany; and the wings to Aeritalia (now Alenia Aeronautica) in Italy.[19] Similarly, tri-national worksharing was used for engines, general and avionic equipment. A separate multinational company, Turbo-Union, was formed in June 1970 to develop and build the RB199 engines for the aircraft, with ownership similarly split 40% Rolls-Royce, 40% MTU, and 20% FIAT. At the conclusion of the project definition phase in May 1970, the concepts were reduced to two designs; a single seat Panavia 100 which West Germany initially preferred, and the twin-seat Panavia 200 which the RAF preferred (this would become the Tornado). The aircraft was briefly called the Panavia Panther, and the project soon coalesced towards the two-seat option. In September 1971, the three governments signed an Intention to Proceed (ITP) document, at which point the aircraft was intended solely for the low-level strike mission, where it was viewed as a viable threat to Soviet defences in that role. It was at this point that Britain's Chief of the Defence Staff announced "two-thirds of the fighting front line will be composed of this single, basic aircraft type". Prototypes and testing The first of more than a dozen Tornado prototypes took flight on 14 August 1974 at Manching, Germany; the pilot, Paul Millett described his experience: "Aircraft handling was delightful... the actual flight went so smoothly that I did begin to wonder whether this was not yet another simulation". Flight testing led to the need for minor modifications. Airflow disturbances were responded to by re-profiling the engine intakes and the fuselage to minimise surging and buffeting experienced at supersonic speeds. According to Jim Quinn, programmer of the Tornado development simulation software and engineer on the Tornado engine and engine controls, the prototype was safely capable of reaching supercruise, but the engines had severe safety issues at high altitude while trying to decelerate. The triple shaft engine, designed for maximum power at low altitude, resulted in severe vibrations while attempting to decelerate at high altitude. At high altitude and low turbine speed the compressor did not provide enough pressure to hold back the combustion pressure and would result in a violent vibration as the combustion pressure backfired into the intake. To avoid this effect the engine controls would automatically increase the minimum idle setting as altitude increased, until at very high altitudes the idle setting was so high, however, that it was close to maximum dry thrust. This resulted in one of the test aircraft being stuck in a mach 1.2 supercruise at high altitude and having to reduce speed by turning the aircraft, because the idle setting at that altitude was so high that the aircraft could not decelerate. The British Ministry of Supply[when?] ordered Chief Engineer Ted Talbot from the Concorde development team to provide intake design assistance to the Tornado development team in order to overcome these issues, which they hesitantly agreed to after noting that the Concorde intake data had apparently already been leaked to the Soviet Union. The German engineers working on the Tornado intake were unable to produce a functional Concorde style intake despite having data from the Concorde team. To make the problem worse, their management team incorrectly filed a patent on the Concorde design, and then tried to sue the British engineers who had provided the design to them. The German lawyers realized that the British had provided the designs to the German team, and requested further information to help their engineers overcome the problems with the Tornado intake, but Chief Engineer Talbot refused. According to Talbot, the Concorde engineers had determined the issue with the Tornado intake was that the engine did not respond to unexpected changes in the intake position, and therefore the engine was running at the wrong setting for a given position of the intake ramps. This was because the Concorde had similar issues due to control pressure not being high enough to maintain proper angles of the intake ramps. Aerodynamic forces could force the intakes into the improper position, and so they should have the ability to control the engines if this occurs. The Tornado intake system did not allow for this. Due to the behaviour of the German management team, the British engineers declined to share this information, and so the Tornado was not equipped with the more advanced intake design of the Concorde. Testing revealed that a nose-wheel steering augmentation system, connecting with the yaw damper, was necessary to counteract the destabilising effect produced by deploying the thrust reverser during landing rollouts. From 1967 until 1984 Soviet KGB agents were provided details on the Tornado by the head of the West German Messerschmitt-B"olkow-Blohm Planning department, Manfred Rotsch. Two prototypes were lost in accidents, both of which had been primarily caused by poor piloting decisions and errors leading to two ground collision incidents; a third Tornado prototype was seriously damaged by an incident involving pilot-induced pitch oscillation. During the type's development, aircraft designers of the era were beginning to incorporate features such as more sophisticated stability augmentation systems and autopilots. Aircraft such as the Tornado and the General Dynamics F-16 Fighting Falcon made use of these new technologies. Failure testing of the Tornado's triplex analogue command and stability augmentation system (CSAS) was conducted on a series of realistic flight control rigs; the variable-sweep wings in combination with varying, and frequently very heavy, payloads complicated the clearance process. Production The contract for the Batch 1 aircraft was signed on 29 July 1976. The first aircraft were delivered to the RAF and German Air Force on 5 and 6 June 1979 respectively. The first Italian Tornado was delivered on 25 September 1981. On 29 January 1981, the Tri-National Tornado Training Establishment (TTTE) officially opened at RAF Cottesmore, remaining active in training pilots from all operating nations until 31 March 1999. The 500th Tornado to be produced was delivered to West Germany on 19 December 1987. Export customers were sought after West Germany withdrew its objections to exporting the aircraft; Saudi Arabia was the only export customer of the Tornado. The agreement to purchase the Tornado was part of the controversial Al-Yamamah arms deal between British Aerospace and the Saudi government. Oman had committed to purchasing Tornados and the equipment to operate them for a total value of lb250 million in the late 1980s, but cancelled the order in 1990 due to financial difficulties. During the 1970s, Australia considered joining the MRCA programme to find a replacement for their ageing Dassault Mirage IIIs; ultimately the McDonnell Douglas F/A-18 Hornet was selected to meet the requirement. Canada similarly opted for the F/A-18 after considering the Tornado. Japan considered the Tornado in the 1980s, along with the General Dynamics F-16 Fighting Falcon and F/A-18, before selecting the Mitsubishi F-2, a domestically produced design based on the F-16. In the 1990s, both Taiwan and South Korea expressed interest in acquiring a small number of Tornado ECR aircraft. In 2001, EADS proposed a Tornado ECR variant with a greater electronic warfare capability for Australia. Production came to an end in 1998; the last batch of aircraft being produced went to the Royal Saudi Air Force, who had ordered a total of 96 IDS Tornados. In June 2011, it was announced that the RAF's Tornado fleet had flown collectively over one million flying hours. Aviation author Jon Lake noted that "The Trinational Panavia Consortium produced just short of 1,000 Tornados, making it one of the most successful postwar bomber programs". In 2008, AirForces Monthly said of the Tornado: "For more than a quarter of a century ... the most important military aircraft in Western Europe."

Tags: